Differences

This shows you the differences between two versions of the page.

--- keyboard:datacomp_dfk777 [11 Apr 2026 23:11] – coolpenguin1
+++ keyboard:datacomp_dfk777 [12 Apr 2026 03:49] (current) – coolpenguin1
@@ Line 20: / Line 20: @@
 ==== Construction ====
 === Case and Internals ===
-The keyboard consists of three parts: a ABS top and bottom case, and an internal assembly
+The keyboard consists of three parts: a ABS top case, painted steel bottom case, and an internal assembly
 ==Top case==
-The top housing is made of ABS plastic\\ Externally, it has a sort of raised "ridge" around the keys that turns into a slope at the top and serves as a pen holder. The top right has a lock-light sticker. \\ Internally, it features standoffs for screws with brass screw inserts, standoffs for holding the case in place and the flip-out feet mechanism.
+The top housing is made of ABS plastic.\\ Externally, it has a sort of raised "ridge" around the keys that turns into a slope at the top and serves as a pen holder. The top right has a lock-light sticker. \\ Internally, it features standoffs for screws with brass screw inserts, standoffs for holding the case in place and the flip-out feet mechanism.
 ==Bottom case==
 The bottom case is made out of a painted metal that can rust which implies it's made out of steel.\\ Externally, it features a cutout for the AT/XT switch, a sticker for said switch, a S/N sticker, a country of origin stamped in the bottom right and six total feet: four being non-slip feet and two flip-out feet for adjusting the keyboard's angle.\\ The Futaba variant features an extra sticker with the keyboard's FCC ID on it\\ Internally, it has a PCB for the AT/XT switch and a couple pieces of rubber and tape to prevent the assembly PCB from shorting.